Tiny Torx Screwdriver

Our Community Forums General Discussion Tiny Torx Screwdriver

  • This topic has 7 replies, 4 voices, and was last updated 4 years ago by Judd.
Viewing 7 posts - 1 through 7 (of 7 total)
  • Author
    Posts
  • #1114049
    peterw_diy
    Participant

    I have a T6 tamper-resistant bit (part of a set like this) I’d be happy to loan you, along with a bit driver handle if you need that. I’m in Alexandria south of Del Ray, PM me for my address.

    #1114050
    n18
    Participant

    Home Depot carries it for $6, but I don’t think it’s the tamper-resistant type:

    https://www.homedepot.com/p/Husky-8-in-1-Precision-Torx-Screwdriver-Set-70381H/302735271

    #1114115
    Judd
    Participant

    Big thanks to Peter for loaning his Torx set to me. I successfully* replaced the battery and back of my Garmin Edge 1000.

    *One of the wires that sends power to the speaker became detached from the battery while attaching it to the motherboard. My Garmin no longer chirps at me which is mostly not a problem except for the rare occasions that I’m using navigation.

    Sent from my iPhone using Tapatalk

    #1114118
    peterw_diy
    Participant

    @Judd 210431 wrote:

    Big thanks to Peter for loaning his Torx set to me. I successfully* replaced the battery and back of my Garmin Edge 1000.

    *One of the wires that sends power to the speaker became detached from the battery while attaching it to the motherboard. My Garmin no longer chirps at me which is mostly not a problem except for the rare occasions that I’m using navigation.

    So… you wanna borrow my soldering iron next? ;-)

    [I’m glad to hear it was relatively successful.]

    #1114121
    jrenaut
    Participant

    Tiny Torx Screwdriver is the name of my next band

    #1114123
    Judd
    Participant

    @jrenaut 210437 wrote:

    Tiny Torx Screwdriver is the name of my next band

    That name paints you in to the corner of being a math rock band.

    Sent from my iPhone using Tapatalk

    #1114130
    Judd
    Participant

    @peterw_diy 210434 wrote:

    So… you wanna borrow my soldering iron next? ;-)

    [I’m glad to hear it was relatively successful.]

    I wish it was solderable. I gave the old college try of sticking the wire back into its hole in the plastic pin connector but I don’t think it was repairable.

    Sent from my iPhone using Tapatalk

Viewing 7 posts - 1 through 7 (of 7 total)
  • You must be logged in to reply to this topic.